Jumping Dolphin Cutters
Price range: £2.00 through £27.00
Jumping Dolphin shaped cutters for metal clay, polymer clay and air dry clay.
Full set contains 12 cutters, 6 sets of mirrored pairs.
Sizes available: 31mm, 26mm, 22mm, 19mm, 16mm & 12mm
Height of cutter: 8mm
Dimensions (approximate):
31mm: 31mm wide from nose to back of tail, 29mm high top of fin to tip of tail
26mm: 26mm wide from nose to back of tail, 24mm high top of fin to tip of tail
22mm: 22mm wide from nose to back of tail, 20mm high top of fin to tip of tail
19mm: 19mm wide from nose to back of tail, 18mm high top of fin to tip of tail
16mm: 16mm wide from nose to back of tail, 15mm high top of fin to tip of tail
12mm: 12mm wide from nose to back of tail, 11mm high top of fin to tip of tail
Direction:
When selecting either left or right facing cutters, please remember the cutting edge will show the squirrel sitting in the opposite direction.
Dolphin facing left: when cut the dolphin is facing towards the left
Dolphin facing right: when cut the dolphin is facing towards the right
Inset detail depth: with clay rolled to 1mm thick (4 playing cards) the inset lines will be 0.3mm deep, leaving 0.7mm of clay for support. If you roll clay 0.7mm (3 playing cards) or less no inset detail will show.
The cutting edge is super fine: 0.2mm-0.3mm, width varies depending on the complexity of the design.
Most cutters have the size embossed on the side. Special or complex shapes do not.
The size is the diameter of the shape when cut, sizes are approximate.
These cutters are designed for metal clay, they will also work for polymer clay and air dry clay.
Please note:
- All cutters are printed to order, please allow *5-7 processing days (not including shipping / in transit days) when ordering.
- Cutters are made of durable but not indestructable PLA plastic. To clean them use warm water only.
- Colour of the cutters may vary. The colour in the photos is not gauranteed.
- Sizes are approximate and may be slightly larger or smaller than stated.
- They cannot withstand heat: do not put in a dehydrator, on a hot plate, in hot water or leave in strong direct sunlight.
- Clay can stick to the cutters. Always use a good release agent or clingfilm. My tips for using the cutters are coming soon!
- The very fine cutting edge can be damaged if cutters are stored haphazardly together.
- A full set (if offered) will have one cutter of each size.
*If you need your order faster, please message me to see if I can fit you in.
See Cutter Care for full details on keeping your cutters in good condition!
